SII DPU-S series Guida Utente Scaricare il pdf (Pagina 22)

- 18 -

Loading the Thermal Paper

1. Turn on the power.

2. Cut the tip of the thermal paper straight

across. New paper can be inserted as is.

(See figure on right)

3. Open the paper cover.

4. Push the tip of the thermal paper into the inlet at the bottom of the

paper holder, until the auto-loader catches it and feeds about 10cm

of it through the paper cutter.

 Load the thermal paper in an area protected from direct sunlight.

• Place the thermal paper on the cover to make feeding easier.

5. Keep pressing the FEED button until the thermal paper feeds

straight and smoothly.

• When the thermal paper is set correctly, the OFFLINE LED stops

blinking and stays on to indicate the printer is still in OFFLINE

mode.

• When the thermal paper is about to run out, red lines appear on

both sides of the thermal paper.

HINT

Paper

Insert

direction

Insertion Slot

NOTE

HINT

The printing surface

is the outside of the

thermal paper roll.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Nessun commento

SII DPU-S series Guida Utente Pagina 22